Local foundation and crawl space specialists in Kentucky, Tennessee and the Southeast Call 800-800-2220™
myfoundation.solutions

Helical Piers

Steel shafts with screw-like plates that are turned into the ground like a giant screw. Ideal for lighter structures, porches and new additions.

How helical piers work

A helical pier is a steel shaft with one or more helix-shaped plates near the tip. A hydraulic motor screws it into the ground. As it turns, the installer monitors torque, which correlates with how much load the pier can support. Once the target torque is reached at a suitable depth, the pier is attached to the footing with a bracket.

Where they’re the right choice

  • Lighter structures that aren’t heavy enough to drive push piers: porches, decks, additions, garages
  • New construction where piers are installed before the building goes up
  • Sites where tension (pulling) capacity is needed as well as compression
  • Areas where good bearing soil is present but rock is very deep

The installation

  1. A small excavation exposes the footing.
  2. The pier is screwed down in sections, with torque recorded along the way.
  3. Once the required torque is reached, a bracket ties the footing to the pier.
  4. The structure is lifted and locked off as needed, and the hole is backfilled.

Strengths and limits

  • Strengths: don’t depend on the weight of the house, install quickly, can be loaded immediately, minimal vibration.
  • Limits: rocky soils, cobbles or shallow rock can stop the helix before it reaches good bearing. In those conditions, push piers or micropiles may be better.

Questions homeowners ask

Helical or push piers: which is better?

Neither is better everywhere. Push piers are often favored for heavy homes over rock; helical piers for lighter loads and deep soils. A good specialist explains why they chose one for your house.

The longer it waits, the bigger the repair.

Get a free estimate from a local specialist.

Get a free estimate