How push piers work
A steel push pier is a heavy-walled steel tube, driven in sections straight down beside or beneath the footing until it reaches bedrock or soil firm enough to carry the house. The driving force comes from hydraulic rams that push against a steel bracket attached to the footing, using the weight of the house as resistance. That means every pier is load-tested as it’s installed: if it can hold the house while being driven, it can hold it afterward.
The installation, step by step
- Small excavations are dug at each pier location along the settled footing.
- The bottom of the footing is prepared so the bracket sits flat and tight.
- A heavy steel bracket is attached under the footing.
- Pier sections are hydraulically driven down, one after another, until they hit refusal on rock or dense soil. The driving pressure is recorded at every pier.
- With all piers installed, hydraulic jacks lift the footing together, a little at a time, to stabilize it and recover as much lift as the house allows.
- The piers are locked off, and the soil is backfilled and compacted.
Where they’re the right choice
- Houses with enough weight to drive the piers: most brick, block and two-story homes
- Areas where rock or dense soil is within reach, which is common across limestone regions
- Lifting settled corners, walls and chimneys
Strengths and limits
- Strengths: very deep reach, every pier load-tested, can lift the structure, minimal disruption to landscaping compared to full excavation.
- Limits: very light structures, like some porches, may not have enough weight to drive them. Helical piers fit those better.
Questions homeowners ask
How many piers will I need?
It depends on the length of footing that’s settling and the weight of the house. Piers are typically spaced every 4 to 8 feet along the affected section.
Will it close my cracks?
Lifting often closes cracks partly or fully. Remaining cracks are repaired once the house is stable.
How long does it take?
Most residential pier jobs take one to three days.
Field note from Shaun Miller: Ask for the installation log. Every push pier should have its final driving pressure and depth written down. That record is your proof each pier was load-tested, and it’s worth keeping with the warranty for when you sell the house.